Hardware Hacking

1.) Remove control head from front of the rig.
2.) Disconnect the cable that connects to the back of the control head.
3.) Four screws hold on the back cover of the control head. Remove them
and the back cover.
4.) Clip the red and blue wires inside the control head. Then, put the rig
back together.
5.) Hold the Function key down on power-up to reset the rig.
6.) You will loose the contents of the rigs memories when you perform this
mod, so be prepared to reprogram them.

This entry was posted on Wednesday, March 30th, 2005 at 4:45 pm and is filed under Alinco, Ham Radio Mods. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.