Hardware Hacking

1)Find the backside of the clarifier knob.
2)Solder the bottom pin to GROUND. 3)Solder a wire to the top pin of the PCB.
This pin should be cut loose from any traces going to it!)
4)Solder that wire to an 8VDC source.This can be found on the second jumper behind the PLL chip(IC-2).
5)Cut D-25.

This entry was posted on Thursday, April 21st, 2005 at 9:52 am and is filed under CB Radio Mods, Radio Shack, Uniden. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.